§ 400-34
Dimensional and density standards
- A. The provisions of Article II, § 400-24D, Dimensional regulations, shall not apply to uses in the SMD.
- B. Land development projects. Two or more commercial structures may be located on the same lot in accordance with the following dimensional regulations:
- (1) Dimensional regulations for commercial land development projects.
- (a) Density. No more than 25% of the gross floor area of the commercial development shall be consumed by any one unit, and any one unit shall not exceed 60,000 square feet; excepted from this requirement shall be any hotel.
- (b) Minimum lot size, commercial: one acre.
- (c) Yard dimensions.
- [1] Front (depth): 20 feet.
- [2] Side (width): 10 feet.
- [3] Rear (depth): 20 feet.
- (d) Minimum separation between buildings: 25 feet between buildings.
- (e) Maximum percent of lot building coverage: 60%.
- (f) Maximum impervious area: 90% of total land area and 90% per lot.
- (g) Maximum building height: No structure shall exceed 60 feet, and no hotel shall exceed 90 feet; however, gables and other architectural elements may extend above these dimensions.
- (h) Maximum accessory building height: 40 feet.
- (i) Two or more buildings are permitted on one parcel.
- (j) In the SMD, only wetlands, water bodies, and associated buffers shall be considered land unsuitable for development and shall be subtracted out of any density calculation.
- (1) Dimensional regulations for commercial land development projects.