Browse another municipality →
Warren
Town of Warren Zoning Ordinance
Read in full Download
§ 32-67

Other requirements

  • A. If the proposed manufacturing operation use involves the division of a lot, tract or parcel of land into two (2) or more lots, tracts, parcels or other divisions of land for sale, lease or other conveyance, or for development, simultaneous or at separate times, and said division of lot, tract or parcel does not meet all of the conditions set out in Rhode Island General Laws 45-23-1 subsections (a) through (d) then, upon the granting of a special use permit by the zoning board of review, the site plan shall be approved by the planning board prior to any issuance of a building permit by the building inspector.

  • B. In addition to the normal information required by the subdivision regulations, the submission to the planning board shall include the following information:

    • 1. Proposed name and location of the manufacturing operation, together with the names and addresses of the applicant and designer or engineer;

    • 2. Scale of plan, one (1) inch to forty (40) feet, or as required by the planning board;

    • 3. Date and north arrow;

    • 4. Contours at two-foot intervals;

    • 5. Boundary lines of proposed development, indicated by a solid line and the total acreage encompassed thereby;

    • 6. Location, widths and names of all existing or prior platted streets, railroad and utility rights-of-way, parks and other public open spaces, permanent buildings and structures, and sections and municipal boundary lines, within five hundred (500) feet of the tract;

    • 7. Existing sewers, water mains, culverts and other underground facilities within the tract, indicating pipe sizes, grades, manholes and locations;

    • 8. Location arrangement and dimensions of automobile parking spaces, width of aisles, width of bays, angle of parking;

    • 9. Location, arrangement and dimensions of truck loading and unloading spaces and docks;

    • 10. Drainage systems and sanitary uses;

    • 11. Locations, heights and materials of walls, fences and screen plantings;

    • 12. Ground cover, finished grades, slopes, banks and ditches;

    • 13. Location and general exterior dimensions of principal and accessory buildings;

    • 14. Location, size, height and orientation of all signs, other than signs on building facades;

    • 15. Preliminary architectural drawings for all buildings;

    • 16. The stages, if any, to be followed in the construction of the development; and

    • 17. A traffic flow chart showing circulation patterns within the confines of the development.